Established 1997

  • Fan Out Control

Hoist Control Fan Out

Distributes single phase 110 volts of AC power from a multicore cable to 4 separate hoists

Fan outs are also referred to in the rigging industry as break out ‘spiders’ and are an integral part of every successful lift where multiple hoists are used. A control fan out connects to a multicore cable which originates at the hoist controller and is responsible to redistribute control commands to individual electric chain hoists. When used in conjunction with a low voltage (LV) hoist controller, the control fan out carries single phase 110 volts of AC power to 4 separate hoists. Each control fan out connects to a multicore cable by means of an industry standard 19-pin female Socapex style connector to 4 separate 4-pole male yellow CEE form connectors via a 1 metre long 1.5 or 2.5 mm2 cross section cable. Our entire plant hire stock of electrical chain hoists, cable and control are all regularly tested and inspected by Rigging Services to ensure safe and dependable operation.

Connectors: Female 19-pin Socapex and 4 Male Yellow CEE Form 4-pole 16A

Cable: Durable, unshielded rubber cable for indoor or outdoor installation in dry, damp or wet environments and hazardous environments (subject to local regulations). The synthetic rubber compound is resistant to ozone, UV rays, sunlight and weathering.

  • 1.5 or 2.5 mm2 cross section
  • 1 metre Length
  • Copper Construction: Class 5 IEC 60228

Cable: H07RN-F; EN 50525-2-21; IEMMEQU < HAR > approved